Yes, the Trailer Valet RVR9 Remote-Controlled Trailer Dolly # TVRVR9 will climb a loading ramp like the # 288-07432 into the back of your truck. I confirmed this with Trailer Valet to ensure that it did not have an out of level sensor that would stop it from working on the ramp. Be sure you are using a ramp that is wide enough as the dolly is 19" wide. view full answer...
The Erickson # EM07435 loading ramps you mentioned would be ideal for getting your push mower up into the bed of your truck.
The ramps are relatively light, at around 15lbs apiece, and are constructed of zinc plated steel for corrosion resistance. The ramp features a non-skid surface that'll make it easier to keep your footing while loading your lawn mower. view full answer...
TheBuyers Products Wheel Chocks, part # 337WC1086UWH would certainly add some insurance when you are loading or unloading your boat on a ramp.
These chocks measure 10" long x 8-1/4" wide x 6" tall. You want to also make sure you turn the engine off and apply the emergency brake when on the ramp. You can never be too cautious. view full answer...
There are no installation instructions for the Ribbed Rubber Trailer Mat, part # 3622RM. As far as traction, it would make sense that installing the mat with the ribs running horizontal would provide a bit more traction than vertical, but I have not heard anyone mention traction issues with the mats installed. If the ribs are running vertical on a ramp it would allow water or snow to run off the mat which could help.
This mat measures 36-inches wide and 22-feet long, so you can cut the... view full answer...
The Dexter DX Series Electric Over Hydraulic Brake Actuator # K71-650 is designed to naturally release heat and moisture. The inside of the housing has fins built in which will help to shed excess heat. So even with prolonged use, you should not have any problems with it overheating. I also can tell you that we have never received a single complaint about excessive heat being an issue. view full answer...